imported>Patrick at 14:41, 15 June 2017

2017-06-15T14:41:31Z

New page

{{Utility Tab Quick Links}}
__TOC__

[[File:Update.jpg|500px|center|Update Tab]]

====Update Firmware Button====

The Update Firmware button will update or reinstall the firmware in the radio that is currently connected to the USB port of your computer.

* Connect the radio to the computers USB port.
* Wait for the main screen to update with the units information. NOTE: If the Update Firmware button is grayed out, no firmware has yet been downloaded for the connected radio. Close and re-run the PocketWizard Utility with your computer connected to the internet.
* Click the Update Firmware button.
* A dialog box will appear confirming the update firmware process has been selected. Click YES or OK to proceed.
* The next dialog box will indicate what firmware release is going to be installed in the unit. Clicking YES will start the install. Clicking NO will cancel the process.
* Click YES. NOTE: DO NOT DISCONNECT OR TURN OFF THE UNIT FROM YOUR COMPUTER WHILE THE UNIT IS UPDATING!
* The progress bars will show the status of the installation.
* For ControlTL radios like the MiniTT1/FlexTT5/FlexTT6, the radios will be reset and previous settings may or may not be able to be reloaded. Regardless, we always recommend a [[Factory_Reset#Reset_B_-_Factory_Defaults|Reset B]]

====Factory Reset====

You can perform a “Factory Reset” from within the [[PocketWizard Utility]] for your ControlTL radio. In addition, when you update your radios via the Utility, a factory reset will be performed automatically. Your previous settings will be saved, and when possible, you will be able to re-load them after the firmware update and factory reset. A large jump in firmware versions or a specific change in the firmware may make it impossible to re-load, so be sure to write down any custom settings for Configuration 1 or Configuration 2 before you reset your radios so you can re-apply them after the upgrade.

* Click "Factory Reset"
* A dialog box that says "Are you sure you want to reset the unit to factory defaults?" will appear. Click "Yes."
*The PocketWizard Utility may flicker, and then will default to the [[Channel Tab]].
*Your radio has now been successfully reset. To see the Factory Default Settings, see the [[Factory Reset#Default Settings|Default Settings]] section of the [[Factory Reset]] page.

Update Tab - Revision history

imported>Patrick at 14:41, 15 June 2017